Aluminium Water Block

• 4mm thick aluminium construction
• 10m cable length
• Scratch resistant top-coat
• Robust, hard-wearing, resistant to corrosion and durable
• Choice of four RAL colours; RAL7016, RAL7021, RAL9005 and RAL9016
• Other colours available, set up cost applies
• EU plug, UK adaptor
• Custom sizing available

Q: What do I need to do before installation?

A: Get your spade and start digging - or have someone do the digging for you! The water block operates with an underground reservoir so you need to site this below ground during installation.

Q: How long is the cable?

A: There's two! The pump and the LED light run on separate circuits; each has a 10m cable.

Q: Can I hard-wire the water block into my property?

A: Yes, but your electrician needs to be careful! The pump is straightforward to hard-wire, but the LED light plug has a built in transformer which if removed will overload your lights causing them to break. Hard-wiring the pump and the lights will void their warranty.

Q: Does the water block require a water supply?

A: No. Water blocks are self-contained units that recycle water through an underground reservoir.

Q: Are water blocks safe for pets to drink out of?

A: Yes, as long as you don't use chlorinated tablets to keep your water clean. Always use non-toxic organic alternatives.

Q: Can I plant directly around the water block?

A: No. The area immediately around the water block has a grill which allows the water to flow down the block and into the underground reservoir. We recommend covering the grill with a large gravel, pebbles or stones.

1. Provide a level, solid surface. If not done carefully, this can cause
   tension which can result in damage to the product.
2. In case of a solid foundation, make a hole in the foundation under the overflow pipe. This hole functions as a passage of the electrical cables and for draining excess water through the overflow pipe. The cables from the pump and the fountain lighting exit the water table through the overflow pipe.
3. Place the water table in the desired position.
4. After positioning the water table, now the fountains and pump can be connected to the PVC distribution pipe.
   Note! Always open the lid of the water table with at least 2 people! In addition, always use the metal rods supplied with the water table. Metal rods are not included with small or circular water tables.
5. Plug the pump into the electrical outlet and check if the fountains are spraying evenly. This can be adjusted inside the water table with the taps on the PVC distribution pipe.